Honda FG110 Manuel d'utilisateur télécharger pdf (Page 28)

SERVICING YOUR TILLER

TRANSMISSION LUBRICATION

The transmission is pre-lubricated at the factory.

At the beginning of each tilling season, or after every

25 hours of use during the season, the transmission

should be filled with grease.

Replacement grease should be a high quality

petroleum based NLGI #2 general purpose grease

usually available in disposable tubes at most

hardware or automotive parts stores.

1. Place the tiller on the left side as shown.

2. Remove the lock pin from the right side tine shaft

by turning it UP [a] and pulling it out [b] as

shown. Wearing heavy gloves, remove both right

side tines.

3. Remove the air vent screw and fill hole screw

from the transmission.

4. Fill the transmission by using a grease gun or

grease applicator at the fill hole screw opening.

Push the gun or applicator against the opening

so as to seal the nozzle of the gun or applicator

against the casting embossment. Apply grease

until grease begins to come out of the top air vent

hole.

5. Reinstall the air vent screw and fill hole screw.

6. Clean the tine shaft and place a few drops of oil

on the tine shaft before installing the tines.

7. Wear heavy gloves and reinstall the tines in the

reverse order of removal.

8. Install the lock pin through the round side of the

tine shaft hole [a], then turn it over [b] to lock it in

place.

[b]

[a]

RIGHT OUTER

TINE (D)

GREASE

GUN

RIGHT INNER

TINE (C)

LOCK PIN

FILL HOLE

SCREW

AIR VENT

SCREW

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Honda FG110 Manuel d'utilisateur Page 28

Commentaires sur ces manuels

Produits connexes et manuels pour Mini-faucheuses Honda FG110