Honda BFP8D Manuel d'utilisateur télécharger pdf (Page 35)

−

−

−

−

−

17.0 in (433 mm)

22.2 in (563 mm)

27.7 in (703 mm)

33

POWER REQUIREMENTS

BOAT TRANSOM

REQUIREMENTS

INSTALLATION POSITION

INSTALLATION

CENTER LINE

02.0in

(0 50 mm)

TTRRAANNSSOOMM HHEEIIGGHHTT

IIDDLLEE

PPOORRTT

Correct and secure installation is

essential for safe boating and good

performance. Follow the installation

instructions provided in this manual.

Before installation, check to be sure

that the outboard motor does not

exceed the recommended maximum

horsepower for the boat on which it

is to be installed. Refer to the boat’s

certification plate for recommended

maximum horsepower. If the

certification plate information is not

available, contact the boat dealer or

manufacturer.

For most applications, the outboard

motor should have a horsepower

rating which provides 80% of the

maximum recommended horsepower

for the boat.

The antiventilation plate of the

outboard motor should be 0 2.0

inches below the bottom of the boat.

Install the outboard motor on the

center of the boat transom.

Honda BF8D/BFP8D/BF9.9D/

BFP9.9D/BF15D/BFP15D/BF20D

and BFP20D outboard motors can be

installed on a boat transom having a

thickness range of 1.3 2.2 inches

(35 57 mm).

Transom HeightType:

S:

L:

X:

When the outboard motor is installed

extremely low, the idle port may be

immersed and the engine may

become hard to start or may run

poorly. Check that the idle port is

high enough from the water level

when the engine is stopped with the

boat fully loaded.

04/03/15 10:27:15 31ZY0600_034

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 136 137

Commentaires sur ces manuels

Pas de commentaire