Honda EM3800SX Manuel d'utilisateur télécharger pdf (Page 22)

＋

＋＋

AC Receptacle Selection

Main power circuit

Main Circuit I

Main Circuit II

Receptacles powered

by each main circuit

Power distribution

EM3800SX:

120V 30A

120V 20A

120/240V 20A

The generator has two separate main power producing circuits.

These two circuits supply equal power to different receptacles

shown when the voltage selector switch is in the 120/240V

position.

Example:

Receptacle 1 has a 10A load connected to it. Receptacle 3 has a 10

A load connected to it. Both receptacles are powered by main

power circuit II. The equation tells us that the total power draw on

circuit II is 20A. This is a substantial overload of this circuit. To

eliminate the excess power draw on circuit II, the load from

receptacle 3 should be switched to receptacle 2. Now circuit I is

powering the 10A load (less than 13.8A) and circuit II is powering

a 10A load (less than 13.8A).

The table shows the specifications when the 120/240V locking

plug receptacle is used for 120V.

2and4

1, 3 and 5

2 4=13.8A rated.

1 3 5=13.8A rated.

When two or more receptacles are used; prevent overloading by

dividing the load between the two power circuits.

The chart below shows the rated load in amperes that can be

connected to each receptacle to balance the generator.

The total rated ampere draw is 27.5A.

03/11/17 18:41:14 31Z21600_021

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 70 71

Pas de commentaire

Honda EM3800SX Manuel d'utilisateur Page 22